**Two affixing options supplied—3M Dual Lock or mechanical fasteners.**

 ===== Dual Lock =====

    - Determine mounting location on board.
    - Trace the border of the mount or tape off a frame.
    - Clean this area and bottom of mount with acetone.
    - Remove tape to expose adhesive.
    - Press strips firmly into each indent on bottom of mount.
    - Connect each opposing lock strip.
    - Remove tape on mated strips to expose all adhesive.
    - Using your drawn or taped border for reference, press the mount firmly onto your board.(“Garage door” facing forward on the Fairing Mount).
    - (Low-Profile Mount) Install computer in mount, with case on, by pulling up on top line.
    - (Low-Profile Mount) Make sure clamping mechanism has firmly grabbed both top and bottom of Atlas.
    - (Fairing Mount) Open “garage door,” slide computer in (no case on).
    - Attach safety tether to foot strap and Atlas leash.

 ===== Mechanical Fasteners =====

    - Determine mounting location on board.
    - Mark the three bolt holes for drilling.
    - Drill M6 or M7 holes 10mm deep.
    - Cover outside threads with glue.
    - Screw in threaded inserts until flush with board; allow glue to cure.
    - Optional— epoxy a layer of composite material over each inert.
    - Optional—add a layer of caulk around each insert.
    - Affix mount with M5 bolts.
    - (Low-Profile Mount) Install computer in mount, with case on, by pulling up on top line.
    - (Low-Profile Mount) Make sure clamping mechanism has firmly grabbed both top and bottom of Atlas.
    - (Fairing Mount) Open “garage door,” slide computer in (no case on).
    - Attach safety tether to foot strap and Atlas leash.